Effect of particle-size distribution on the surface appearance of glazed surface

Glazes have great influence on most of the final properties of sanitary wares, such as color, glossy, and surface roughness. Generally, these properties have been changed by chemical composition and firing parameters. In addition, the selection of particle-size distribution of raw glaze can affect on the surface appearance and cleanability of glazed surface. In this paper, raw glazes were milled in ball mill for different time. Prepared glaze slurry was applied to green bodies, later dried and fired. The same glaze was also uniaxially pressed to form cylindrical sample; the specimen was placed on substrate surface and fired in hot stage microscope. The glaze evolution upon heating was recorded by CCD camera, the contact angle between molten glaze and substrate was measured to determine the wettability. The results showed that particle-size distributions have great influence on the melting behavior of glaze and the surface appearance of glazed ceramics.     

Effect of pyrolysis characteristics on ignition mechanism and NO emission of pulverized coal during oxy-fuel combustion

The effect of pyrolysis behavior on the ignition mechanism was investigated by thermogravimetric technique. The pyrolysis tests show that Datong bituminous coal (DT) pyrolyzes earlier and releases volatiles faster than does Guohua bituminous coal (GH). During oxy-fuel combustion, more volatiles accumulated around DT particles can be ignited easily with increasing oxygen concentration which results in the heterogeneous ignition transforming to homogeneous ignition, while for GH, less volatile is released during devolatilization and the coal particles are more likely ignited heterogeneously. After the transformation of ignition mechanism, the ignition temperature of DT decreases significantly, but the combustibility index S is not appreciably affected. The effect of pyrolysis characteristics on NO emissions was studied by a fixed-bed reactor. It is found that compared to GH, DT released NO more quickly and intensively which leads to more fuel-N converting to NO. With the rise in oxygen concentration, the NO yields of both coals reach the peak values at 40 % oxygen concentration and then decline mainly due to the enhanced homogeneous NO reductions at higher oxygen concentration. With the rise in furnace temperature, the NO yields of coal samples increase first and then decrease with a maximum at 900 °C which is possibly a result of the competing reactions of volatile-N oxidation and reduction in the process of NO formation.     

Luminescent Hybrid Materials Based on Laponite Clay

The spectroscopic behavior of ionic Eu³⁺ or Tb³⁺ complexes of an aromatic carboxyl‐functionalized organic salt as well as those of the hybrid materials derived from adsorption of the ionic complexes on Laponite clay are reported. X‐ray diffraction (XRD) patterns suggest that the complexes are mainly adsorbed on the outer surfaces of the Laponite disks rather than intercalated within the interlayer spaces. Photophysical data showed that the energy‐transfer efficiency from the ligand to Eu³⁺ ions in the hybrid material is increased remarkably with respect to the corresponding ionic complex. The hybrid material containing the Eu³⁺ complex shows bright red emission from the prominent ⁵D₀→⁷F₂ transition of Eu³⁺ ions, and that containing the Tb³⁺ complex exhibits bright green emission due to the dominant ⁵D₄→⁷F₅ transition of Tb³⁺ ions.     

New low-molecular-weight electroluminescent materials for green organic light emitting diodes

1. Download : Download full-size image

     

用于组胺检测的MWCNT/ZnO/Nafion复合物膜修饰的电化学发光传感器的研究

基于含有氨基类物质对三联吡啶钌电化学发光的促进作用,建立了直接测定组胺的电化学发光方法。通过MWCNT/ZnO/Nafion复合物膜修饰玻碳电极(GC)固定三联吡啶钌,研究了此工作电极在组胺溶液中的ECL发光行为。在最优的实验条件下,组胺质量浓度在1.0~1.0×104ng/mL范围内时其对数值与电化学发光信号呈良好的线性关系(R2=0.9968),检出限为0.64 ng/mL,组胺的加标回收率为96%~103%,RSD为2.7%。     

树枝状聚酰胺胺负载TEMPO的合成及其催化分子氧氧化醇的性能

以乙二胺和丙烯酸甲酯为原料,经过重复Michael和酯氨解反应,制备出二代(2.0 G)树枝状聚酰胺胺(PAMAM).PAMAM与2,2,6,6-四甲基哌啶酮氮氧自由基经缩合、还原将PAMAM与2,2,6,6-四甲基哌啶氮氧自由基(TEMPO)键连,得到PAMAM负载的TEMPO(PAMAM-TEMPO).采用1H NMR、13C NMR以及FT-IR等手段对中间体及最终产物进行了表征.将PAMAM-TEMPO与CuBr2以及2,2-联吡啶结合构成催化体系,用于分子氧为氧化剂的醇的选择性氧化反应,结果表明该体系对苄基以及烯丙基伯醇的氧化显示出良好的催化活性和选择性.结果还证明,TEMPO的负载使氧化产物醛很容易与催化体系分离,而且催化剂可以循环使用.     

基于等离子体型Ag@AgBr插层K4Nb6O17的可控合成及光催化性能

在微波辅助条件下采用离子交换和光致还原的方法将Ag@AgBr纳米粒子插层进入K4Nb6O17层间,制备了具有等离子体共振效应的可见光催化剂(记作K4Nb6O17/Ag@AgBr).在胺交换过程中采用不同链长的有机胺对酸交换产物进行柱撑,通过铌酸钾层间距的变化实现层间Ag@AgBr纳米粒子的形貌调控.利用XRD,SEM,EDX,UV-Vis等手段对复合催化剂进行结构、形貌和性质分析,并对复合光催化剂进行了可见光降解亚甲基蓝、甲基橙和苯酚的性能研究.结果表明:改性后的复合光催化剂在可见光区的响应大大增强;3种复合光催化剂对目标污染物均具有良好的可见光催化活性,其中十二胺柱撑的Ag@AgBr插层K4Nb6O17复合光催化剂对亚甲基蓝的移除效果最好.     

铜绿微囊藻液中提取叶绿素a作为基准物用于荧光光度法测定叶绿素含量

用乙醇从铜绿微囊藻中提取叶绿素a并用分光光度法测得提取液中叶绿素a的质量浓度为1 902.5μg·L-1,以叶绿素a作为标准物质,用荧光光度法测定叶绿素含量。叶绿素a的质量浓度在30~1 800μg·L-1范围内与荧光强度呈线性关系。试验表明:该提取液在冰箱4℃条件下保存,5h内其荧光值的相对误差为±2.5%;在pH 3~9范围内应用时,荧光值的相对误差为±5.0%;在温度5℃~30℃范围中使用时,荧光值的相对误差为±3.0%,证明提取液的稳定性能满足使用要求。与叶绿素标准品同时测定了5个水样中的叶绿素含量,经t检验所得结果之间无显著差异,说明可用叶绿素a代替叶绿素标准品作为荧光光度法中的基准物质。     

稀土元素取代对Ti_(0.26)Zr_(0.07)V_(0.24)Mn_(0.1)Ni_(0.33)贮氢合金结构和电化学性能的影响

研究了5种稀土元素部分取代V对Ti0.26Zr0.07V0..24Mn0.1Ni0.33合金的微观结构和电化学性能的影响。结果表明,Ti0.26Zr0.07V0.24Mn0.1Ni0.33和Ti0.26Zr0.07V0.24-xMn0.1Ni0.33REx(x=0.005;RE=La,Ce,Nd,Ho,Y)均由体心立方结构的钒基固溶体相和六方结构的C14 Laves相组成。在合金中加入稀土元素,会使合金中两相的晶胞体积同时增大。稀土元素部分取代V均改善了合金电极的活化性能。La和Nd元素取代后,合金电极的最大放电容量明显增加,而Ce的取代提高了合金电极的循环稳定性。Ce,Nd,Ho,Y均改善了合金电极的倍率放电性能。合金电极在高温状态下表现出了良好的放电性能,其中Nd在333 K时放电容量可达550.4 mAh·g-1。稀土元素对荷电保持率的影响各异。     

磷钼酸/PMMA静电纺丝纤维的制备及形貌研究

通过静电纺丝技术制备了磷钼酸/PMMA复合纤维,研究了PMMA的相对分子质量、磷钼酸的含量及混合溶剂中DMF与乙醇的体积比对复合纤维形貌及直径的影响。通过扫描电镜(SEM)对复合纤维的形貌进行了观察,并测试了不同条件纺丝溶液的电导率、黏度和表面张力。研究发现,PMMA的相对分子质量和DMF与乙醇的体积比对复合纤维的形貌影响较为明显,磷钼酸的含量对复合纤维的直径影响显著。较为理想的纺丝条件为:PMMA的重均分子量为60000,纺丝液中磷钼酸的含量为16mg/mL,DMF与乙醇的体积比为6∶4。